(1) Presetting: rotate the brightness knob counterclockwise to the bottom, move the vertical and horizontal position to the middle, and the attenuation is placed in the highest level, and the scanning is placed in the "outer X gear";
(2) Turn on the power again, and wait for one or two minutes after the light is on for preheating before carrying out relevant operations;
(3) First adjust the grayscale, then focus, and then adjust the horizontal and vertical displacement to make the highlights in the center of the appropriate area;
(4) Adjust scanning, scanning fine tuning and X gain, observe scanning;
(5) Unplug the outer X gear to the appropriate position in the scanning range file, and observe the voltage waveform in the vertical direction changing according to the law of sines and cosines provided by the machine;
(6) To study the external voltage from Y input and indirectly into the oscilloscope, adjust each gear to the appropriate position, you can observe the voltage waveform (and time changes of the image)(synchronous polarity switch can make the starting point of the image from the positive half cycle or negative half cycle start;
(7) If you want to observe the vertical offset of bright spot (such as when applied with a constant current voltage), you can adjust the scan to "outer X gear". (different oscilloscopes may operate in different ways), etc.
(1) Insert the oscilloscope probe into the socket of channel 1, and put the attenuation on the probe into "1" gear;
(2) Put channel selection in CH1 and coupling mode in DC file;
(3) Insert the probe into the pinhole of the calibration signal source, and the light trace appears on the oscilloscope screen;
(4) Adjust the vertical knob and horizontal knob to stabilize the waveform displayed on the screen, and put the vertical fine-tuning and horizontal fine-tuning in the calibration position;
(5) The number of cells occupied by the waveform in the vertical direction is multiplied by the indicating value of the vertical attenuation knob to obtain the amplitude of the calibration signal.
(6) The number of bars occupied by each period of the waveform in the horizontal direction is multiplied by the indicating value of the horizontal scanning knob to obtain the period of the calibration signal (the inverse of the period is the frequency).
(7) In general, the frequency of the calibration signal is 1kHz and the amplitude is 0.5v, which is used to calibrate the internal scanning oscillator frequency of the oscilloscope. If it is abnormal, the corresponding potentiometer of the oscilloscope (internal) should be adjusted until it is consistent.